Save settings/script temporary before executing

Stefan · 2011-04-16 20:57

Arrgh, again i dropped my PascalScript code because i forgot
to copy it to clipboard first before clicking [Add Rule]
and sure i have produced an infinity loop
and have to kill ReNamer by TaskManager
so my code is gone and i have only an older version in my clipboard.

So how about saving the code automatically temporary to %temp%
after clicking [Add Rule] and before executing the code?
So i can grab it from there.

Sure, now i remember i can save it always under an temp name first like "_aaaaa" too
..i only have to think about it... so take this post only to give me some sympathy for my loose
and take it as an hint to always remember to press Ctrl+S while modifying an PascalScript code
and save it temporary (perhaps always to the same name '_temp') before clicking on [Add Rule]

den4b · 2011-04-17 11:05

For what it's worth, here is my sympathy

It is possible to save rules after every modification, but I don't think we should go this route.

den4b Forum

#1 2011-04-16 20:57

Save settings/script temporary before executing

#2 2011-04-17 11:05

Re: Save settings/script temporary before executing

Board footer